The Best Way to Charge Lead Acid Batteries
News 2022年12月26日 103
The correct way to charge lead-acid batteries
The most taboo thing about lead-acid batteries is that they should be recharged when they are completely discharged. In this case, the battery life will be greatly reduced. Do not perform deep discharge many times. After the undervoltage and power failure, you must not continue to drive with power on. The intermittent discharge of the electric vehicle battery is the most harmful to the battery.
- When the lead-acid battery is running with floating charge, the voltage of the single battery of the battery should not be lower than 2.20V. If the voltage of the single battery is lower than 2.20V, equalization charging is required. The method of balanced charging is: charging voltage 2.35V/piece, charging time 12 hours.
- When the lead-acid battery is floating-charged, the voltage of the single battery of the battery should not be lower than 2.20V. If the voltage of the single battery is lower than 2.20V, equalization charging is required. The method of balanced charging is: charging voltage 2.35V/piece, charging time 12 hours.
- The charger is placed in a fixed place, do not bump it, even if you carry it, you must fully consider the fault caused by bumps.
- Try not to use fast charging for lead-acid batteries, if not necessary, do not use more than twice in a month.
Precautions for charging lead-acid batteries
When charging, you should open the liquid filling hole cover of the battery, and keep the room well-ventilated, so as to avoid the danger caused by the release of a large amount of gas at the end of charging;
When charging, the positive and negative cables between the battery and the charger should be connected first, and then the power supply of the charger should be connected, otherwise, sparks may be generated when connecting the cables, causing an explosion accident;
Absolutely do not over-discharge and over-charge. Over-charging is the process of forming a workshop, which will cause the metal layer of the grid to become thinner and easily break the grid. Over-discharge will cause the plate to vulcanize, the active sponge tissue will fail, and the life of the plate will be shortened;
During the charging process of the battery, the temperature of the battery should be checked at any time to avoid overheating;
Avoid using the charger under direct sunlight or rain in the open air, and avoid working in an environment with large dust or corrosive gases.
ZXGroup/ZXferroalloy/Caloong New Energy